181 posts · Joined 2015. #10 · Oct 20, 2017. i just ordered a couple six packs from Amazon: Castrol Power1 10W-50 Synthetic 4T Motorcycle Oil - 1 Quart Bottle, (Pack of 6) $51.24. That is about $8.50 / quart, and I am certain it is every bit as good as the grossly overpriced Motorex stuff. ---.
Hit the jump for more information on the KTM 125 Duke. 2013 KTM 125 Duke. And the low fuel consumption ensures a reasonable level of economy. Simply a genuine KTM – and setting new standards
Hi, I've just done the 20 000 km service on my 2013 KTM Duke 690 last week-end at my KTM dealer. The dealer have changed all the fluid (clutch, brake, oil) and they replace my rear brake pads. The bike run like a charm ! On the 10 000 km service, last year, they put Motorex Cross Power 4T Engine Oil 10W60 in the bike.
The KN-155 K&N Oil Filter for the 2021 KTM 125 Duke with a 125 engine is designed to operate with all synthetic, conventional & blended motor oils. 2021 KTM 125 Duke125 Oil Filter The store will not work correctly when cookies are disabled. I have had the oil pressure sensor swapped for the new revision and the latest ecu software applied which has fixed the oil warning light not turning off on hot start issue. However the oil light now sometimes comes on when taking off from a stand still. The conditions seem to be: - Taking off from a stand still, with revs around 3000rpm
If it stays on after the bike is running for more than a couple of seconds then you have a problem. Check oil level and viscosity. oil which is too thin or too thick can cause this issue, but it is usually a sign of something more serious like excessive oil clearance on the cam or bigend. 1. level 2.
Preparatory work – Stand the motorcycle upright on a horizontal surface. Main work – Check the engine oil level. Info After switching off the engine, wait one minute before checking the level. The engine oil must be between the lower and upper edge of the oil level viewer.
My ktm is indicating low oil pressure in my ktm duke 200 bs6. Even though I had just serviced my bike and change oil . And the oil in the bike is also in perfect level. I also changed the sensor recently but still I am facing this issue. Hi, I had same issue before, turns out the oil filter was collapsing while the engine ran.
\n ktm duke 125 oil level
KTM says when the engine is at operating temp to stand the bike level, shut it off, wait one minute, and the correct oil level is between the lower and upper edge of the oil level viewer. It seems that you are saying that it is the same with the engine cold. Check the oil window. The light will only tell you if there in no oil pressure. Which is a very bad thing. throttlemaster77 DUKE 390 • 4 yr. ago. Check oil level, top up if necessary and then take it to service center. Don't top up more than 300ml. Take out the oil pressure sensor and install a pressure gauge to check at what pressure she is running. If too low, open her up and search for possible problems, camshaft bearings, oil jets, oil filter by-pass valve etc. If this is too much work, disconnect your oil pressure sensor, spray the electrical connections with WD40 or electro-clean .
  • djhza1t5o6.pages.dev/209
  • djhza1t5o6.pages.dev/131
  • djhza1t5o6.pages.dev/125
  • djhza1t5o6.pages.dev/147
  • djhza1t5o6.pages.dev/373
  • djhza1t5o6.pages.dev/286
  • djhza1t5o6.pages.dev/78
  • djhza1t5o6.pages.dev/429

    • ktm duke 125 oil level